Power storage

Power storage is the storing of some form of enrgy that can be drawn upon at a later time to perform some useful purpose.

History: Power storage as a natural process is billions of years old - the energy produced in the initial creation of the Universe has been stored in stars such as our Sun, and is now being used by humans directly (e.g. through solar cells) or indirectly (e.g. by growing crops). As a purposeful activity power storage has certainly existed since pre-history, though it was often not recognized as such. An example would be the use of logs or boulders as defensive measures in ancient forts - the logs or boulders would be collected at the top of a hill, and the energy thus stored would be released as a defense against invaders.

A more recent application was the control of waterways to power water mills for processing grain or powering machinery. Often complex systems of reservoirs and dams were constructed to store and release water (and the power it contained) when required.

Power storage only became a major concern, however, with the introduction of electricity. Unlike the other common power sources at the time, such as natural gas, electricity had to be used as it was generated. This meant that changes in demand were difficult to cater for without either cutting supplies at times, or having expensive excess capacity.

An early solution was the battery, but this is of limited use both due to its small capacity and relatively high cost. A similar solution with the same type of problems is the capacitor.

Some areas of the world (Washington and Oregon in the USA, and Wales in the United Kingdom are examples) have used geographic features to store large quantities of water in reservoirs at the top of hills, using excess electricity at times of low demand to pump water into the reservoirs, then letting the water fall through generators to retrieve the energy when demand peaks.

A number of other technologies have been investigated, but to date no widely available, affordable solution to the challenge of mass power storage has been found.

Reasons: Load Levelling. The demand for electricity from consumers and industry is constantly changing, broadly within the following categories:

• Seasonal (during dark winters more electric lighting and heating is required, while in other climates hot weather boosts the requirement for air conditioning)
• Weekly (most industry closes at the weekend, lowering demand)
• Daily (such as the peak as everyone arrives home and switches the television on)
• Hourly (one method for estimating television viewing figures in the United Kingdom is to measure the power spike when advertisements are shown and everyone goes to switch the kettle on)
• Transient (fluctuations due to individual's actions, differences in power transmission efficiency and other small factors that need to be accounted for)

There are currently three main methods for dealing with changing demand:

• Electrical devices generally having a working voltage range that they require, commonly 110-120V or 220-240V. Minor variations in load are automatically smoothed by slight variations in the voltage available across the system.
• Power plants can be run below their normal output, with the facility to increase the amount they generate almost instantaneously. This is termed 'Spinning Reserve'.
• Additional power plants can be brought online to provide a larger generating capacity, though this typically takes 12-18 hours (or longer for nuclear plants), and so is used to deal with large, predictable variations (such as seasonal).

The problem with relying on these last two methods in particular is that they are expensive, making poor use of expensive generating equipment. Power Storage is a potential solution to this. Power plants would be able to run at their peak efficiency 24 hours a day throughout the year. At times when demand was lower than the total amount generated the surplus could be diverted to some storage mechanism. This storage resource could then be tapped when demand exceeded supply, without having to use additional expensive resources. This could work on a daily, weekly or even seasonal basis, depending on the characteristics of the storage mechanism.

Portability
Reliability

Types: Capacitor
Batteries
Hydro-electric
Compressed Air Energy Storage (CAES)
Superconducting Magnetic Energy Storage (SMES)
Flywheel
Fuel Cells